Cooling fan
Removing a cooling fan
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
Steps
1. Disconnect the cooling fan cable from the system board connector.
2. Remove the cable from the cable retention tabs.
NOTE: Observe the routing of the cable as you remove it from the system.
3. Press the release tab, and lift the cooling fan from the cooling fan cage.
NOTE: The numbers on the image does not depict the exact steps. The numbers are just for representation of
sequence.
Figure 27. Removing a fan
NOTE: Ensure to disconnect the cooling fan 1 cable from the connector on the power interposer board.
Installing and removing system components 37
To Next Page
Loading...
