Dell PowerEdge T310 - Installing the Chassis Intrusion Switch

Installing System Components 135
Figure 3-26. Removing and Installing the Chassis Intrusion Switch
Installing the Chassis Intrusion Switch
1 Align the chassis intrusion switch with the securing bracket notch.
See Figure 3-26.
2 Slide the switch into the securing bracket notch. See Figure 3-26.
3 Connect the chassis intrusion switch cable to the connector on
the system board.
4 Close the system. See "Closing the System" on page 86.
5 Place the system upright on a flat surface.
6 Reattach any peripherals and connect the system to an electrical outlet.
7 Turn on the system and attached peripherals.
1 chassis intrusion switch 2 chassis intrusion switch cable
3 intrusion connector on the
system board
1
2
3
book.book Page 135 Wednesday, August 19, 2009 4:40 PM