Dell PowerEdge T310 - Closing the System

86 Installing System Components
Figure 3-5. Opening and Closing the System
Closing the System
1 Ensure that all internal cables are connected and folded out of the way.
2 Ensure that no tools or extra parts are left inside the system.
3 Place the bottom edge of the cover, opposite from the cover release latch,
into the slots in the system chassis. See Figure 3-5.
4 Lower the cover into the chassis.
5 Press the latch end of the cover into the chassis until the latch
locks into place.
6 Turn the lock on the cover release latch clockwise to the locked position.
See Figure 3-5.
1 cover release latch lock 2 cover release latch
3 system cover 4 chassis slots
1
2
4
3
book.book Page 86 Wednesday, August 19, 2009 4:40 PM