Dell PowerEdge T310 - Installing the Cooling Shroud

Installing System Components 89
Figure 3-6. Removing and Installing the Cooling Shroud
Installing the Cooling Shroud
1 Carefully lower the cooling shroud into the system holding by the
touch point.
2 Ensure that no cables are pinned under the edges of the cooling shroud.
3 Secure the cable into the bracket on the side of the cooling shroud.
4 Replace the expansion card stabilizer. See "Installing the Expansion Card
Stabilizer" on page 87.
5 Close the system. See "Closing the System" on page 86.
1 cooling shroud 2 expansion card stabilizer
3 expansion card stabilizer touch
points (2)
4 cable bracket
5 cooling shroud touch point
1
2
3
5
4
book.book Page 89 Wednesday, August 19, 2009 4:40 PM