Installing Enclosure Components 47
Installing the Backplane
1
Align the holes on the backplane with the holes on the enclosure.
2
Tighten the captive screw to secure the backplane to the chassis.
See Figure 3-14 for PowerVault MD1200 or Figure 3-15 for
PowerVault MD1220.
3
Replace the screws that secure the backplane to the chassis.
See Figure 3-14 for PowerVault MD1200 or Figure 3-15 for
PowerVault MD1220.
4
Align the slots on the EMM/power supply cage with the tabs on the
chassis. See Figure 3-13.
5
Push the EMM/power supply cage toward the front of the enclosure.
6
Replace the screws that secure the EMM/power supply cage to the chassis.
7
Replace the control panel. See "Installing the Control Panel" on page 44.
8
Replace the power supply/cooling fan modules. See "Installing a Power
Supply/Cooling Fan Module" on page 41.
9
Replace the hard drives. See "Installing a Hard Drive" on page 32.
10
Connect all the cables to the enclosure.
11
Turn on the enclosure and the host server.
book.book Page 47 Monday, December 7, 2009 4:51 PM
To Next Page