Installing 2.5–inch hard drive into the hard drive bracket
1. Flex the side of the hard drive bracket, to align and insert the pins on the bracket into the hard drive.
2. Insert the hard drive into the hard drive bracket until it clicks into place.
3. Install the:
a. 2.5 inch hard drive assembly
b. Front bezel
c. Side Cover
4. Follow the procedure in After working inside your computer.
Installing 2.5–inch hard drive assembly
1. Insert the drive assembly into the slot on the computer until it clicks into place.
2. Close the front panel door.
3. Connect the SATA cable and the power cable to the connectors on the hard drive.
4. Install the:
a. Front bezel
b. Side Cover
5. Follow the procedure in After working inside your computer.
Optical drive
Removing optical drive
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. Side Cover
b. Front bezel
3. Open the Front panel door.
4. To remove optical drive assembly:
a. Disconnect the data cable and power cable from the connectors on the optical drive [1].
NOTE:
You may need to unroute the cables from the tabs under the drive cage to allow you to disconnect the cables
from the connectors.
b. Close the front panel door [2].
28
Field service information
To Next Page
Loading...
Need help?
General