Dell Precision M6800 - Removing the Camera; Installing the Camera; Removing the Display Panel

Removing the Camera
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the:
a) battery
b) display bezel
3. Perform the following steps to remove the camera:
a) Disconnect the camera cable.
b) Remove the screw that secures the camera module to the computer.
c) Remove the camera module from the computer.
Installing the Camera
1. Connect the camera cable.
2. Place the camera module in its slot on the computer.
3. Tighten the screw to secure the camera module to the computer.
4. Install the:
a) display bezel
b) battery
5. Follow the procedures in After Working Inside Your Computer .
Removing the Display Panel
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the:
a) battery
b) display bezel
3. Remove the screws that secure the display panel to the display assembly. Flip the display panel over.
33