Dell S3221QS - OSD Warning Messages

Operating your monitor │ 55
OSD warning messages
When the monitor does not support a particular resolution mode, the following
message is displayed:
The current input timing is not supported by the monitor display.
Please change your input timing to 3840x2160, 60Hz or any other
Dell 32 Monitor
This means that the monitor cannot synchronize with the signal that it is receiving
from the computer. See Monitor specifications for the Horizontal and Vertical
frequency ranges addressable by this monitor. Recommended mode is 3840 x
2160.
Before the DDC/CI function is disabled, the following message is displayed:
The function of adjusting display setting using PC application will be
disabled.
Do you wish to disable DDC/CI function?
Yes
No
Dell 32 Monitor
S3221QS
When the monitor enters the Standby Mode, the following message appears:
Dell P2418HZ
Dell 32 Monitor
Going into Standby mode...
S3221QS
If you press any button other than the power button, the following messages will
appear depending on the selected input: