Dell S6000–ON - S6000-ON, S4048-ON, or S3048-ON System Information

PsuFanStatusMonitorTest ......................... PASS
PsuPresenceTest ................................. PASS
PsuSourceTypeTest ............................... PASS
PsuStatusMonitorTest ............................ PASS
RtcPresenceTest ................................. PASS
SfpPlusModulePresenceTest ....................... PASS
ShowTemperatureTest ............................. PASS
SmcBoardRevisionTest ............................ PASS
SsdPresenceTest ................................. PASS
UsbAAccessTest .................................. PASS
UsbHostControllerAccessTest ..................... PASS
LEVEL 1 DIAGNOSTIC
B50282PhyExternalLinkTest ....................... PASS
B50282PhyLinkSpeedTest .......................... PASS
DDR3MemTest ..................................... PASS
FanCntlrSpeedTest ............................... PASS
FanTrayEepromAccessTest ......................... PASS
I2cStressTest ................................... PASS
MainBoardEepromAccessTest ....................... PASS
PsuEepromAccessTest ............................. PASS
RtcFunctionTest ................................. PASS
RtcRolloverTest ................................. PASS
SfpPlusEepromAccessTest ......................... PASS
Starting test: SsdFileCopyTest ......
ERROR:Dir /f10/slot0 already present on MS-DOS partition
SsdFileCopyTest ................................. PASS
TSensorAccessTest ............................... PASS
UsbFileCopyTest ................................. PASS
LEVEL 2 DIAGNOSTIC
CpuSnake1gMacLpbkTest ........................... PASS
CpuSnake1gPhyLpbkTest ........................... PASS
CpuSnakeSfpPlusMacLpbkTest ...................... PASS
CpuSnakeSfpPlusPhyLpbkTest ...................... PASS
MgmtPortMacLoopbackTest ......................... PASS
MgmtPortPhyLoopbackTest ......................... PASS
--------- Group Test Statistics ---------
Total : 47
Passed : 47
Failed : 0
Not Appl : 0
Elapsed time : 00H:07M:27S
Stop reason : after completion
DCLI->
NOTE
: Entering the reload command at the DCLI prompt reloads the ONIE or OS installed on the system. It does not reload
the Diagnostic tools.
S6000–ON, S4048–ON, or S3048–ON system
information
To view your S6000–ON, S4048–ON, or S3048–ON system information; for example, the model, part number, serial number, and service
tag, follow these steps.
1 Boot into ONIE.
2 Enter the onie-syseeprom command.
ONIE:/ # onie-syseeprom
26
Dell EMC diagnostics