Dell Studio 1735 - Removing the Coin-Cell Battery; Replacing the Coin-Cell Battery

Back to Contents Page
 Coin-Cell Battery
Dell™Studio1735/1737ServiceManual
Removing the Coin-Cell Battery
Replacing the Coin-Cell Battery



Removing the Coin-Cell Battery

1. Follow the procedures in Before You Begin.

2. Turn the computer over and remove the base cover (see Removing the Base Cover).

3. Use a plastic scribe to push the coin cell battery forward and upward to release it from the slot.
Replacing the Coin-Cell Battery

1. Replace the coin cell battery with the positive (+) side facing upwards.

2. Replace the base cover (see Replacing the Base Cover).

3. Slide the battery into the bay until it clicks into place.
Back to Contents Page

CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as a connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
1
coin-cell battery