Dell Studio 1735 - Display Inverter and Hinges


2. Remove the display bezel (see Display Bezel).

3. Remove the display panel (see Removing the Display Panel).

4. Turn the display panel over and place it on a clean surface.

5. Lift the tape that secures the display cable to the connector on top and disconnect the cable from the connector.

Replacing the Display Panel Cable

1. Reconnect the display cable to the connector on top and secure it with the tape.

2. Replace the display panel (see Replacing the Display Panel).

3. Replace the display bezel (see Replacing the Display Bezel).

4. Follow the instructions in Replacing the Display Assembly.
Display Inverter

Removing the Display Inverter

1. Follow the instructions in Display Assembly.

2. Remove the display bezel (see Display Bezel).

3. Disconnect the cables from the connectors on either side of the inverter board.

4. Remove the screw that secures the inverter board and lift the inverter board off the display assembly.

Replacing the Display Inverter
1
tape
2
display cable
1
screw
2
inverter board