Back to Contents Page
Palm Rest
Dell™Studio1735/1737ServiceManual
Removing the Palm Rest
Replacing the Palm Rest
Removing the Palm Rest
1. Follow the instructions in Before You Begin.
2. Press and eject any installed cards from the ExpressCard slot and the 8-in-1 memory card reader.
3. Remove any installed memory modules and Mini-Cards (see Memory and Communication Cards).
4. Follow the instructions in Display Assembly.
5. Turn the computer upside down and remove the eight screws from the computer base.
6. Turn the computer top side up and remove the four screws from the top of the palm rest.
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface
(such as the back panel) on the computer.
To Next Page
Loading...
