Dell Studio 1735 - Page 8


3. If the computer is connected to a docking device (docked), undock it. See the documentation that came with your docking device for instructions.


4. Disconnect all telephone or network cables from the computer.

5. Press and eject any installed cards from the ExpressCard slot and the 8-in--1 memory card reader.

6. Disconnect your computer and all attached devices from their electrical outlets.



7. Turn the computer over.

8. Slide and click the battery latch release.

9. Slide the battery out of the battery bay.

10. Press the power button to ground the system board.
Back to Contents Page

NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug the cable from the network device.
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you service the computer.
NOTICE: To avoid damage to the computer, use only the battery designed for this particular Dell computer. Do not use batteries designed for
other Dell computers.
1
battery
2
battery latch release