Dell Vostro 1310 - Display; Display Assembly

Back to Contents Page
 Display
Service Manual
Display Assembly
Display Bezel
Display Inverter
Display Panel
Display Cable
Camera and Microphone Assembly
Display Assembly

Removing the Display Assembly


1. Follow the instructions in Before Working on Your Computer.

2. Remove the hard drive (see Removing the Hard Drive).

3. Remove the WLAN card (see Removing a WLAN Card).

4. Remove the hinge cover (see Removing the Hinge Cover).

5. Remove the keyboard (see Removing the Keyboard).

6. In sequential order, remove the four numbered M2.5 x 5-mm screws from the base of the display assembly.

7. Remove the captive grounding screw, then disconnect the display cable from the display cable connector on the system board.

8. Lift the display cable and antenna cables from beneath the tabs on the palm rest.


9. Lift the display assembly out of the computer.
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
NOTICE: Ensure that the display cable and the antenna cables do not get caught beneath the plastic tabs on the palm rest.