Replacing the Hard Drive
1. Slide the hard drive into the hard-drive bracket.
2. Replace the two hard-drive bracket screws to secure the hard drive to the hard drive bracket.
3. Slide the hard drive into the hard drive connector until the drive is fully seated.
4. Replace the hard-drive compartment cover, aligning the notches.
5. Replace the M2.5 x 5-mm screw to secure the cover.
6. Install the operating system for your computer, as needed. For information about reinstalling the operating system, see the Setup and Quick Reference
Guide for your computer on support.dell.com.
7. Install the drivers and utilities for your computer, as needed. For information on reinstalling drivers and utilities, see the Setup and Quick Reference Guide
for your computer on support.dell.com.
Back to Contents Page