Dell Vostro 1310 - Display Bezel


Replacing the Display Assembly


1. Align the display hinges with the holes in the base of the computer, then lower the display into place.


2. Route the display cable and antenna cables beneath the plastic tabs on the palm rest.

3. Slide the antenna cables through the hole in the palm rest and the base of the computer.

4. Connect the display cable to the display cable connector on the system board.

5. Replace the captive grounding screw.

6. In sequential order, replace the four M2.5 x 5-mm screws in the base of the display assembly.

7. Replace the keyboard (see Replacing the Keyboard).

8. Replace the hinge cover (see Replacing the Hinge Cover).

9. Close the display and turn the computer over.

10. Replace the WLAN card (see Replacing a WLAN Card).

11. Replace the hard drive (see Replacing the Hard Drive).
Display Bezel

Removing the Display Bezel


1. Follow the instructions in Before Working on Your Computer.
1
display cable connector
2
captive grounding screw
3
antenna cables (3)
4
display assembly
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
NOTE: This procedure assumes that you have completed the removal procedure first.
NOTICE: Ensure that the display cable and antenna cables are properly routed and secured beneath the plastic tabs on the palm rest.
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.