2. Install the display hinge caps.
3. Install the display assembly.
4. Install the wireless card.
5. Install the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever applicable.
6. Install the base cover.
7. Follow the procedure in After working inside your computer.
Display panel
Removing the display panel
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever applicable.
4. Remove the wireless card.
5. Remove the display assembly.
6. Remove the display hinge caps.
7. Remove the display bezel.
8. Remove the display hinges.
About this task
NOTE: This procedure applies only to computers with a plastic chassis.
The following images indicate the location of the display panel and provide a visual representation of the removal procedure.
Removing and installing Field Replaceable Units (FRUs)
103
To Next Page
Loading...
