6. Gently flip the display panel assembly forward, peel back the tape that secures the display cable to the connector on the rear
of the display panel.
NOTE: Ensure that the panel has a clean and smooth surface to rest on, to prevent damage.
7. Disconnect the display cable from the connector on the display panel and remove the display panel.
NOTE:
The display panel is assembled with the display brackets as a single service part. DO NOT pull the two pieces of
elastic tape and separate the brackets from the panel.
Installing the display panel
CAUTION: The information in this section is intended for authorized service technicians only.
108 Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
