Steps
1. Loosen the four captive screws that secure the heat sink to the system board.
NOTE: Loosen the four captive screws in the reverse sequential order mentioned on the heat sink [4 > 3 > 2 > 1].
2. Lift the heat sink off the system board.
Installing the heat sink
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
If either the system board or the integrated heat sink is replaced, use the thermal grease provided in the kit to
ensure that thermal conductivity is achieved.
The following image indicates the location of the integrated heat sink and provides a visual representation of the installation
procedure.
Removing and installing Field Replaceable Units (FRUs)
67
To Next Page
Loading...
