NOTE: This procedure applies only to computers shipped with a plastic chassis.
2. Install the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever applicable.
NOTE: This procedure applies only to computers shipped with a plastic chassis.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
Display hinge caps
Removing the display hinge caps
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever applicable.
4. Remove the wireless card.
5. Remove the display assembly.
About this task
NOTE: This procedure applies only to computers with a plastic chassis.
The following images indicate the location of the display hinge caps and provide a visual representation of the removal
procedure.
90
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
