Steps
1. Place the power button in the slot on the palm-rest and keyboard assembly.
2. Align the screw hole on the power button to the screw hole on the palm-rest and keyboard assembly.
3. Replace the screw (M2x2) to secure the power button to the palm-rest and keyboard assembly.
Next steps
1. Install the I/O daughter-board.
2. Install the fan.
3. Install the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever applicable.
4. Install the base cover.
5. Follow the procedure in After working inside your computer.
Power button with optional fingerprint reader
Removing the power button with optional fingerprint reader
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever applicable.
4. Remove the fan.
5. Remove the I/O daughter-board.
About this task
NOTE: This procedure applies only to computers shipped with a power button with optional fingerprint reader installed.
The following image indicates the location of the power button with optional fingerprint reader and provides a visual
representation of the removal procedure.
78
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
