Removing and Installing Parts 123
12
If you removed an add-in network connector:
a
Enter system setup (see "System Setup" on page 174), go to
Onboard
Devices
and select
Integrated NIC
, and then change the setting
to
On
.
b
Connect the network cable to the integrated connector on the back
panel of the computer. See "Back Panel Connectors" on page 20.
Bezel
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from
the electrical outlet before removing the cover.
Removing the Bezel
1
Follow the procedures in "Before You Begin" on page 101.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 103).
book.book Page 123 Thursday, June 14, 2007 6:23 PM
To Next Page
Loading...
