154 Removing and Installing Parts
Removing the I/O Panel
NOTE: Note the routing of all cables as you remove them so that you can re-route
them correctly when installing the new I/O panel.
1
Follow the procedures in "Before You Begin" on page 101.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 103).
3
Remove the bezel (see "Removing the Bezel" on page 123).
NOTICE: When sliding the I/O panel out of the computer, be extremely careful.
Carelessness may result in damage to the cable connectors and the cable routing
clips.
4
Disconnect all the cables that are connected to the I/O panel from the
system board.
5
Remove the screw that secures the I/O panel.
6
Carefully remove the I/O panel from the computer.
1 I/O panel clamp 2 I/O panel 3 screw
4 cables 5 I/O panel clamp slot
1
2
3
4
5
book.book Page 154 Thursday, June 14, 2007 6:23 PM
To Next Page
Loading...
