180 Appendix
Changing Boot Sequence for Future Boots
1
Enter system setup (see "Entering System Setup" on page 174).
2
Use the arrow keys to highlight the
Boot Sequence
menu option and press
<Enter> to access the menu.
NOTE: Write down your current boot sequence in case you want to restore it.
3
Press the up- and down-arrow keys to move through the list of devices.
4
Press the spacebar to enable or disable a device (enabled devices have a
checkmark).
5
Press plus (+) or minus (–) to move a selected device up or down the list.
Clearing Forgotten Passwords
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions located in the Product Information Guide.
1
Follow the procedures in "Before You Begin" on page 101.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 103).
3
Locate the 3-pin password connector (PSWD) on the system board.
4
Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.
book.book Page 180 Thursday, June 14, 2007 6:23 PM
To Next Page
Loading...
