166 Removing and Installing Parts
3
Replace the cables that you removed from the system board.
4
Replace the processor and the heat sink assembly (see "Installing the
Processor" on page 159).
NOTICE: Ensure that the heat sink assembly is correctly seated and secure.
5
Replace the memory modules into the memory sockets at the same
locations from which you removed them (see "Memory" on page 111).
6
Replace any add-in cards on the system board.
7
Replace the computer cover (see "Replacing the Computer Cover" on
page 166).
8
Connect your computer and devices to an electrical outlet, and turn
them on.
9
Verify that the computer works correctly by running the Dell Diagnostics
(see "Dell Diagnostics" on page 86).
Replacing the Computer Cover
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions located in the Product Information Guide.
1
Ensure that all cables are connected, and fold cables out of the way.
2
Ensure that no tools or extra parts are left inside the computer.
3
Align the tabs at the bottom of the computer cover with the slots located
along the edge of the computer.
4
Press the computer cover down and slide it towards the front of the
computer until you feel a click or feel the computer cover securely
installed.
5
Ensure that the cover is seated correctly.
6
Replace and tighten the two screws that secure the computer cover.
book.book Page 166 Thursday, June 14, 2007 6:23 PM
To Next Page
Loading...
