156 Removing and Installing Parts
Removing the Processor Fan/Heat Sink Assembly
NOTICE: Do not touch the fan blades when you are removing the processor
fan/heat sink assembly. This could damage the fan.
1
Follow the procedures in "Before You Begin" on page 101.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 103).
3
Disconnect the processor fan cable from the system board (see "System
Board Components" on page 106).
4
Carefully move away any cables that are routed over the processor fan/heat
sink assembly.
5
Loosen the four captive screws securing the processor fan/heat sink
assembly and lift it straight up.
CAUTION: Despite having a plastic shield, the heat sink fan assembly may be
very hot during normal operation. Be sure that it has had sufficient time to cool
before you touch it.
1 captive screws (4) 2 processor fan/heat sink
assembly
2
1
book.book Page 156 Thursday, June 14, 2007 6:23 PM
To Next Page
Loading...
