Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the left-side cover.
3. Remove the front cover.
4. Remove the memory.
5. Remove the solid-state drive.
6. Remove the hard drive.
7. Remove the graphics card.
8. Remove the wireless card.
9. Remove the coin-cell battery.
10. Remove the media-card reader.
11. Remove the fan shroud.
12. Remove the Serial module, if applicable.
13. Remove the VGA module, if applicable.
14. Remove the fan and heat-sink assembly.
15. Remove the processor.
About this task
The following image indicates the slots and connectors on your system board.
Removing and installing Field Replaceable Units (FRUs) 75
To Next Page
Loading...
