Dell Vostro 3460 - Installing the Power Connector; Removing the Camera; Installing the Camera

Installing the Power Connector
1. Place the power connector in its location on the base of the chassis.
2. Tighten the screw to secure the power connector.
3. Install the:
a) display-hinge cover
b) display assembly
c) system board
d) WLAN card
e) palmrest
f) keyboard
g) base cover
h) battery
4. Follow the procedures in After Working Inside Your Computer .
Removing the Camera
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the:
a) battery
b) keyboard
c) palmrest
d) display assembly
e) display bezel
3. Flip the camera module. Peel off the sticker covering the camera cable. Disconnect the camera cable. Lift the
camera module upwards and away from the display assembly.
Installing the Camera
1. Connect the camera cable to the camera module.
2. Align and place the camera module to its original position on the display assembly.
30