Replacing the speakers
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Using the alignment posts on the palm-rest assembly, place the speakers on the
palm-rest assembly.
2 Replace the four screws (M2x2) that secure the speakers to the palm-rest
assembly.
3 Route the speaker cable on the system board and adhere the tape to the system
board.
4 Connect the speaker cable to the system board.
5 Adhere the tape securing the speaker cable to the system board.
Post-requisites
1 Replace the battery.
2 Replace the base cover.
33
To Next Page
Loading...
