Delsys Tringo - Base Station; Base Station Features

11
Sensor LED Indicator Status
Base Station
Figure 2. Trigno Base Station.
Each Base Station is equipped with the following features:
• recharging cradle for 16 sensors
• high speed USB communication with PC
• 64-channel analog output connector (16 EMG, 48 ACC)
• ± 5V analog output range
• detachable antenna
• full trigger capability (Start/Stop, Input/Output)
• communication & power feedback LEDs
• convenient carry case design
Status LED Behavior LED
Data Streaming Flashing green, 1 Hz
Scanning Alternating green/amber flash, 1Hz
Pairing Successful Rapid green flashing, 3x, button depressed
Pairing Unsuccessful Rapid red flashing, 3x, button depressed
Mode Switch Rapid green flashing, 3x
Firmware Update Rapid green flashing, 3x
Battery Charging Solid amber, in cradle
Charging Complete Solid green, in cradle
Charging Error LED off, sensor in cradle, cradle powered up
Sensor Off LED off
1 Wireless Sensor 5 Analog Output Connectors
2 Base Station 6 Trigger Port
3 USB Port 7 Antenna
4 Power Jack/Power Supply 8 EMGworks Software
1
2
6
4
7
5
3