26 Trigno Wireless System User’s Guide
TM
Audible Warnings
This option will generate an audible “ping” along with a
small message, whenever a sensor falls out of range or it’s
battery is excessively low.
Mode Control (Analog Output Software Only)
In the Analog Output application, the sensor mode is controlled
on the Mode Control tab of the Configuration dialog.
Information on mode control is available through our EMGworks
online help:
http://www.delsys.com/Products/EMGworks.html
Test Panel
The Test Panel is used to verify the analog signal connections with
the data acquisition module by outputting predefined and unique
signals on each channel. The test signals are sinusoidal in nature
and defined by an amplitude, a frequency and an offset. The
To Next Page
Loading...