MINOR 500 option: set point settings
Setting (5 to 30°C) of the Comfort set
point (19°C by default) for the probe 1 of
zone 1.
Setting (5 to 30°C) of the Economy set
point (16°C by default) for the probe 1 of
zone 1.
Confirm and go to the next setting.
Confirm and go to the set point settings
for the next probe.
Repeat the operations for each probe.
When the last probe is set, you can set the Frost
Protection set point for all the zones.
To exit the mode, turn the knob to another mode.
This mode is used to modify the Comfort and Economy set
points of each probe. Tur n the knob to .
Setting (5 to 15°C) of the Frost Protection
set point (8°C by default) for all the zones.
Confirm the modification
- 19 -- 18 -
Programming
Check your program
Press the button repeatedly to check the accuracy
of the Comfort and Economy periods you created.
Programming zone 2 (on the CALYBOX 120)
The programming for zone 2 is available after pressing
(OK) of the day 7 of the zone 1
Exiting the programming mode
Turn the knob to another mode
Program
profile
Ver ification of the
different or
periods
Time slot
consulted
COMMENTS: Depending on the configuration made
during installation, programming can be weekly or
daily. Likewise, this programming may be done in
increments of one hour, 30 minutes, or 15 minutes. To
change these settings, refer to the “installation guide”,
or contact our customer service department or your
installer.