DELTA DORE Tybox 1137 - Menu 2-17 Resetting the Boiler;Heat Pump Operating Hours Meter; Associating to the Tydom App; Association with a Door;Window Magnetic Contact; Association with a Phone Transmitter

9
Menu 2-17 Reseing the boiler/heat pump operating hours meter
Default seing: O
No
Yes
6. Associating to the Tydom app
Open the Tydom app on your smartphone or tablet, then select:
Seings -> My devices -> Add device -> Heating -> Hydraulic -> Tybox 1137 (RF6000 +)
Aer associating with the Tydom app, the Tybox automatically activates programming via Tydom (menu 1-10 = 1),
and removes access to menus 1-02, 1-03, 1-08, 2-05 and 2-06.
You can activate pre-heat on the Tydom app if you want to use it (see § Pre-heat function).
For more information, refer to the section § “Operation in connected mode”.
7. Association with a door/window magnetic contact
Linking with a door/window magnetic contact means the heating is switched to Frost Protection if a window is
opened (for more than 10 seconds).
8. Association with a phone transmitter
Refer to the transmier manual for a description of controlling the heating using the phone.
Once the reset is applied, the 2-17 menu
automatically switches back to 0.
IMPORTANT:
For the Tydom time programming to work, the Tybox must be set to the “AUTO” position.
1
2
3
... ... ...
OFF
> 3s
❶ Press the receiver buon for 3
seconds until the red LED ashes.
❷ Briey press the detector buon. ❸ Make sure that the receiver LED
has stopped ashing.
1
2
3
... ... ...
OFF
> 3s
1 2
abc
3
def
4
ghi
5
jkl
6
mno
7
pqrs
8
tuv
9
wxyz
*
#
0
❶ Press the receiver buon for 3
seconds until the red LED ashes.
❷ From the transmier's main
menu, tap #400, then tap 1:
the transmier announces
"Conguration in progress..." and
indicates the number of connected
receivers.
❸ Make sure that the receiver LED
has stopped ashing.