Delta Electronics AC Motor Drive VFD-E - B.8.2 How to Operate the Digital Keypad

Appendix B Accessories|
B-20 Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11
B.8.2 How to Operate the Digital Keypad
To s hift d ata
Setting direction
Setting PLC Mode
Setting Mode
Setting parameters
(When operation source is digital keypad)
enter PLC2 mode
enter PLC1 mode
START
GO START
NOTE:
In the selection mode, press
to set the parameters.
Success to
set parameter.
Input data error
or
NOTE ：
In the parameter setting mode, you can press
to return the selecting mode.