Delta Electronics ASDA-A2 Series - Page 259

Chapter 8 Servo Parameters
8-14 Revision January 2011
Motion Control Parameters
Control
Mode
Parameter Name Function Default Unit
PT PR S T
P5-95 CSDS
Motion Control: Macro Parameter
2
0 N/A

P5-96 CSDS
Motion Control: Macro Parameter
1
0 N/A

P5-97
CSDS Motion Control: Macro Command
100 pulse
 
 
P5-98 EVON
Event Rising-edge Trigger
Command
(OFF  ON
)
0 N/A

P5-99 EVOF
Event Falling-edge Trigger
Command
(ON 
OFF)
0 N/A

Explanation of symbols (marked after parameter)
(
★) Read-only register.
(
▲) Parameter cannot be set when Servo On (when the servo drive is enabled).
(
) Parameter is effective only after the servo drive is restarted (after switching power off
and on).
(
) Parameter setting values are not retained when power is off.
Call 1(800)985-6929 for Sales
deltaacdrives.com
sales@deltaacdrives.com
Call 1(800)985-6929 for Sales
deltaacdrives.com
sales@deltaacdrives.com