Need help?Do you have a question about the Delta 22-660 and is the answer not in the manual?
Instructions for assembling the optional 50-314 stand for the planer.
Procedures for mounting the planer unit onto the assembled stand.
Guide to attaching the handle for adjusting the planer head height.
Steps for installing the knobs used to secure the planer head position.
Instructions for attaching the protective belt guard to the machine.
Details on how to mount the motor onto the belt guard assembly.
Steps for installing the motor pulley and connecting the gear box belt.
Procedure for fitting the belt onto the cutterhead pulley.
How to set the correct tension for the cutterhead drive belt.
Steps to properly adjust the tension of the gear box drive belt.
Instructions for installing the control switch on three-phase units.
Guide for attaching the cover panel to the belt guard.
Details on wiring and connecting the single-phase model to power.
Instructions for connecting the three-phase model to electrical power.
Guide on how to turn the planer on and off.
Explanation of the motor overload protection system and reset procedure.
How to adjust the planer head for depth of cut.
Instructions for engaging and disengaging the feed rolls.
How to adjust the spring tension for the infeed roll.
How to adjust the spring tension for the chipbreaker.
Procedure for changing the gear box oil annually.
Instructions for assembling the optional 50-314 stand for the planer.
Procedures for mounting the planer unit onto the assembled stand.
Guide to attaching the handle for adjusting the planer head height.
Steps for installing the knobs used to secure the planer head position.
Instructions for attaching the protective belt guard to the machine.
Details on how to mount the motor onto the belt guard assembly.
Steps for installing the motor pulley and connecting the gear box belt.
Procedure for fitting the belt onto the cutterhead pulley.
How to set the correct tension for the cutterhead drive belt.
Steps to properly adjust the tension of the gear box drive belt.
Instructions for installing the control switch on three-phase units.
Guide for attaching the cover panel to the belt guard.
Details on wiring and connecting the single-phase model to power.
Instructions for connecting the three-phase model to electrical power.
Guide on how to turn the planer on and off.
Explanation of the motor overload protection system and reset procedure.
How to adjust the planer head for depth of cut.
Instructions for engaging and disengaging the feed rolls.
How to adjust the spring tension for the infeed roll.
How to adjust the spring tension for the chipbreaker.
Procedure for changing the gear box oil annually.
General| Motor Power | 15 Amp |
|---|---|
| Planing Width | 13 inches |
| Planing Depth | 1/8 inch |
| Weight | 83 lbs |
| Cutterhead Speed | 10, 000 RPM |
| Number of Knives | 2 |
| Model | 22-660 |
| Max Cutting Width | 13 inches |
| Max Cutting Depth | 1/8 inch |
| Horsepower | 2 HP |
| Voltage | 120 V |
| Phase | 1 |
| Feed Rate | 26 feet per minute |
| Type | Portable |
To Next Page
