To Next PageTo Next Page
Need help?Do you have a question about the Delta 22-540 and is the answer not in the manual?
General| Type | Portable Planer |
|---|---|
| Motor | 15 Amp |
| Cutterhead Speed | 10, 000 rpm |
| Feed Rate | 26 feet per minute |
| Number of Knives | 2 |
| Model | 22-540 |
| Dust Port Size | 4 inches |
| Max Cutting Depth | 1/8 inch |
Covers essential safety guidelines for tool operation, including personal protective equipment and work area maintenance.
Details critical safety measures for starting, stopping, using the tool, and awareness of environmental hazards.
Specific safety instructions for planer setup, operation, knife handling, and workpiece security.
References to safety standards from ANSI, OSHA, and the National Safety Council for woodworking machinery.
Guidance on electrical circuit requirements, extension cords, and motor operational specifications for safe use.
Essential procedures and warnings for proper tool grounding to prevent electric shock hazards.
Tables detailing minimum gauge requirements for extension cords based on amperage, voltage, and length.
Introduction to the Delta Model 22-540 Portable Planer, highlighting its features and specifications.
Instructions for safely unpacking the planer, removing protective coatings, and recommended cleaning materials.
Step-by-step guide for attaching the raising and lowering handle to the planer's shaft.
Procedure for lowering the infeed and outfeed extension tables to be level with the planer table.
Instructions for operating the ON/OFF switch and securing it in the OFF position for safety.
Guide to adjusting the planer's head assembly to control the depth of cut using the handle.
Recommendations for maximum depth-of-cut based on wood type and width, and potential motor strain.
Step-by-step guide on how to plane wood, including preparing the material and ensuring proper feed.
Instructions for inspecting and replacing motor brushes, including wear indicators and replacement procedures.
Guidance on lubricating the planer's gearbox, feed roller bushings, and chains for optimal performance.
