Need help?Do you have a question about the Delta RC-63D and is the answer not in the manual?
Instructions for starting and stopping the machine using the power switch.
How to adjust the table height using the control lever and handwheel.
How to change the feed roll speed settings for the planer.
How to adjust the table rollers for proper stock feeding.
Inspection and maintenance of anti-kickback fingers for safety.
Steps to assemble the dust chute for dust collection.
Procedure to check and adjust the drive belt tension.
Procedure to check and adjust the feed roll belt tension.
How to reposition cutterhead inserts on RC-63N models.
How to adjust spring tension on the feed rollers.
How to check and adjust the table height scale pointer.
Information on the supplied gage block and how to make one.
To Next Page
General
