20
Fig. 53
5. Fig. 53 shows the spindle sander being used in the
vertical position. It is advisable to raise or lower the table
periodically to prevent spot wear and improve drum life.
STORAGE
The Oscillating Spindle Sander has a convenient storage
area for spindles, fence, miter gage, and any other
components of the machine that are not in use.
Fig. 54 illustrates components of the Oscillating Edge
sander stored in the base of the machine.
Fig. 54
Fig. 52
4. Fig. 52 shows sanding at 90 degrees to the table
with the miter gage.
Fig. 51
4. Fig. 51 shows sanding at 45 degrees to the table
with the miter gage.
To Next Page
Loading...
