Delta 36-085 User Manual

6
IMPORTANT: DO NOT LIFT THE MITER SAW BY THE
SWITCH HANDLE. THIS ACTION CAN CAUSE MIS-
ALIGNMENT. ALWAYS LIFT THE MACHINE BY THE
BASE OR CARRYING HANDLE.
1 - Miter Saw
2 - Dust Bag
3 - Work Clamp
4 - Wrench
Fig. 4
2
4
3
1
ASSEMBLY INSTRUCTIONS
WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE TOOL TO THE POWER SOURCE
UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE
ENTIRE OWNER’S MANUAL.
ATTACHING TABLE LOCK HANDLE
Fig. 5
Fig. 7Fig. 6
1. Thread the table lock handle (A) Fig. 5, into the hole
(B) in the arm bracket (C).
2. Figure 6 illustrates the table lock handle (A) attached
to the saw.
ROTATING TABLE TO
0 DEGREE POSITION
1. Loosen the table lock handle (A) Fig 6 one or two
turns and depress the index lever (B).
2. Rotate the table to the left until the index stop
engages with the 0 degree positive stop (Fig. 7). Tighten
table lock handle (A).
A
B
C
B
A
A
5
6
7
5 - Table Lock Handle
6 - Extension (2)
7 - Stock Stop
8 - Retaining Bracket (2)
8
CARTON CONTENTS

Delta 36-085 Specifications

General

Brand	Delta
Model	36-085
Category	Saw
Language	English