13
REPOSITIONING MOTOR FOR STORAGE
When the saw is not in use, the motor can be repositioned so it hangs straight down at the
rear, enabling you to move the saw closer to the wall. This can be accomplished by
removing the belt from the arbor pulley and repositioning the motor and motor mounting
plate, as shown in Fig. 25.
Fig. 25
Fig. 26
Fig. 27
ASSEMBLING
BLADE GUARD AND
SPLITTER ASSEMBLY
WARNING: DISCONNECT MACHINE FROM
POWER SOURCE.
1. Fasten the rear splitter mounting bracket (A) Fig. 26,
to the rear trunnion using the two 1/4-20 x 3/4"- hex
head screws (B) and flat washers. Do not completely
tighten the two screws (B) at this time.
2. With two 7/8″ wrenches supplied, remove the saw
blade from the saw. Raise saw arbor to its highest
position.
3. Remove screw and large washer (C) Fig. 27, from
the inside splitter mounting bracket.
B
A
C
To Next Page
Loading...
