19
TROUBLESHOOTING
For your safety, turn on/off switch to the OFF position and unplug the saw from the power source before performing any of the
trouble shooting steps below.
1. Motor is too hot:
• Turn off motor and let it cool down to room temperature
• Check and clean ventilation openings
• If the above actions do not fix the problem, call the Customer Care at 1-800-223-7278.
2. Motor does not run:
• Verify that all electrical connections are secure
• Test and reset the safety breaker on the power cord ground fault.
• Check that the power source is 120v AC
• If the above actions do not fix the problem, call the Customer Care at 1-800-223-7278
3. Pump does not pump water to table:
• The water in the tray is not deep enough
• The water hose is loose or has come off at the pump
• The pump electrical cord is not firmly inserted into the intended receptacle
• The filter foam in the pump housing is dirty and/or blocked
4. Movement of the sliding tray is not smooth
• The rails are dirty and have build-up from use. Clean rails and guide rollers. Then lubricate them with spray on water
resistant lubricant.
To Next Page
Loading...
