Delta ASD-B2-0221-B - Page 170

ASDA-B2 Chapter 7 Parameters
Revision May, 2018 7-9
Planning of Digital Input / Output and Output Setting Parameter
Parameter Abbr. Function Default Unit Control Mode
Related
Section
P1-54 PER Position Completed Range 12800 pulse O
Tab le
7.2
P1-56 OVW
Output Overload Warning
Level
120 % O O O
Tab le
7.2
(★) Read-only register, e.g. parameter P0-00, P0-10 and P4-00, etc.
(▲)
Setting is invalid when Servo On, e.g. parameter P1-00, P1-46 and P2-33, etc.
()
Not effective until re-power on or off the servo drive, e.g. parameter P1-01 and
P3-00.
()
Volatile parameters, e.g. parameter P2-30 and P3-06.