To Next Page

To Previous Page

ASDA-M Chapter 8 Parameters

Revision December, 2014 8-39

NOTE

When the source of external pulse is from the high-speed differential signal

and the setting value is 0 (the high-speed filter frequency is 3.33Mpps at the

moment), then:

If the user uses 2~4MHz input pulse, it is suggested to set the filter value to 4.

Note: When the signal is the high-speed pulse specification of 4 Mpps and the

settings value of the filter is 4, then pulse will not be filtered.

Delta ASD-M-0721 Series User Manual

Questions and Answers: