Delta DVP-ES3 Series User Manual

DVP-ES3 Series Operation Manual
6-30
_6
In the online monitoring mode, you can select a device, then right-click the device, and the click a command on
the context menu. During a test, you can change the status of a device or the value in a device by clicking an
item on the context menu.
Before you change the status of a device, make sure the operation does not cause damage to
equipment or personnel.
The table below describes the items in the context menu. The Force command only applies to input and output
contacts.
Item Description
Set On Set the contact selected to ON
Set Off Set the contact selected to OFF
Rising-edge Trigger
No matter what the state of the selected contact is, the system sets the contact to
OFF, and then sets it to ON.
Falling-edge Trigger
No matter what the state of the selected contact is, the system sets the contact to
ON, and then sets it to OFF.
Force Force an input contact or output contact ON or OFF
Force Device List Force several input contacts or output contacts in the tables ON or OFF
To change the value in a device, right-click the device, click Change Present Value, and set a present value in
the Enter Present Value dialog box.

Delta DVP-ES3 Series Specifications

General

Brand	Delta
Model	DVP-ES3 Series
Category	Controller
Language	English