Chapter 8 Hardware Configuration
You can set email trigger modes as follows.
CPU Error
Trigger sending an email if an error occurs in the CPU module. Refer to the Operation manuals for more information
about errors occurring in CPU modules. After you select CPU Error, select Fatal Error Only or All Errors in the list at
the right side of the option.
a) Fatal Error Only: Send an email if a fatal error occurs in the CPU module.
b) All Errors: Send an email if an error occurs in the CPU module.
CPU (RUN<=>STOP)
Trigger sending an email when the CPU module begins to run, or when the CPU module stops running.
Bit Status Change
Trigger sending an email if the state of a bit device specified meets a set condition. For example, if X0 switches from
OFF to ON, it triggers sending an email. To set a condition, click the
button in the following dialog box.
To Next Page
Loading...
