Delta DVP-ES3 Series

Chapter 10 CANopen Function and Operation
10-9
10
Product
Model
Function
IFD9503
The IFD9503 gateway converts CANopen to
Modbus, and connects a device (with an
RS-232 or RS-485 interface) that conforms to
the standard Modbus protocol to a CANopen
network. You can connect up to 15 devices.
DVPCP02-H2
The CANopen slave module is connected to
the right side of an EH2 series PLC. It can
connect the EH2 series PLC to a CANopen
network.
IFD6503
This analyzes CANopen network data, and
has ports both ends for a CAN interface and a
USB interface. Use it to monitor CAN network
data, or allow CAN nodes to transmit the
data. The product is used with the Netview
Builder software.
ASD-A2-xxxx-M
servo driver
This servo driver has a built-in CANopen
interface. It controls positioning, speed, and
torque.
VFD-C2000/CP2000/C200
series AC motor drives
This AC motor drive has a built-in CANopen
function, and controls positioning, speed,
and torque. For the C2000/CP2000 series AC
motor drives, you must purchase a
CMC-COP01 to provide the CAN interface.
Only the C200 series AC motor drive has the
built-in CANopen interface.
VFD-EC series AC motor
drive
The EC series AC motor drive has a built-in
CANopen interface. It controls speed and
torque.