Ethernet Communication Module DVPEN01-SL
DVP-PLC Operation Manual
19
Opening DVPEN01-SL setup page by RS-232
1. Select “RS232" as the transmission type in communication setting. You will have to designate a
communication port. When DVPEN01-SL is searched by RS-232, you do not need to set up the
parameters (i.e. data length, parity, stop bits and baud rate).
2. After setting up the communication port, press “broadcast search” icon. If the searching is
successful, the setup page for DVPEN01-SL will open automatically.
To Next Page
Loading...
