Ethernet Communication Module DVPEN01-SL
DVP-PLC Operation Manual
24
5.4 Setting up E-Mails
E-mail is the abbreviation of electronic mail, which transmits mails through the network. DVPEN01-SL has
E-Mail functions for the user to pre-save a segment of text messages, which can be a descriptive message or
error message, into the subject of the E-Mail. When the E-Mail is triggered, DVPEN01-SL will send the
messages to the user by E-Mail.
DVPEN01-SL offers 4 sets of E-Mail information, and you can self-define the register or bit information to be
read. When the trigger occurs, DVPEN01-SL will add the set register or bit present value read to the E-Mail.
Every set of E-Mail information is able to contain maximum 100 continuous register data.
Setting up DVPEN01-SL mail
1. SMTP Server:
The E-Mail will first be sent to SMTP server, and SMTP server will send it to the designated
address. For example, assume there is an E-Mail to be sent to test@delta.com.tw
, and the
SMTP server is 172.16.144.121. The E-Mail will be sent to SMTP server first, and the server will
further send it to the recipient test@delta.com.tw
.
2. Subject of E-Mail:
You can enter text message in the column, and the message will be placed in the subject of the
E-Mail and sent to the recipient. DVPEN01-SL is able to contain 1 ~ 4 E-Mail subjects (max. 63
English characters are allowed).
You can select additional information for the E-Mail. Every set of E-Mail is able to contain 100
continuous addresses of registers.
3. E-Mail of Sender:
Maximum 63 English characters are allowed.
4. E-mail of Recipient:
You can enter 4 E-Mail addresses. One mail can be sent to 4 addresses (max. 63 English
characters are allowed).
5. Select recipients:
After you have set up all the parameters for the E-Mail, you will need to select recipients. The
To Next Page
Loading...
