Delta E Series Software Instructions

Recipe Setting Software Instruction
10
2.3.3 Force mode
The force mode clearly defines the final pressing force, and is suitable for where pressing force is
strictly regulated.
Pressing conditions: In force mode, the spindle will press down at the [Pressing Velocity] until it
reaches the [Pressing Force] based on the PID adjustment speed after hitting the work piece, and
wait for the [Pressing Time], then execute the next step or return to [Working Origin]. If the
[Pressing Force] is not reached during the process, the spindle will move to the [Max. Position],
the work piece will be judged as NG, and the spindle will return to the [Working Origin].
Supplementary limiting conditions:
After the spindle reaches the [Pressing Force], the servo press will check whether the position is within
the range of [Maxi. Position] and [Mini. Position]. If it is, the work piece will be deemed as OK; if not, it
is deemed as NG.
Working
origin
Standby position,
standby time
Standby velocity
Pressing force,
pressing time
Pressing velocity + PID speed
Original velocity

Delta E Series Specifications

General

Series	E Series
Type	Inverter
Frequency	50 Hz / 60 Hz
Protection Features	Over voltage, Over current, Short circuit, Over temperature
Dimensions	Varies by model
Weight	Varies by model
Storage Temperature	-40°C ~ +70°C